Skip to main content

Install the cross bar

Use this information to install the cross bar.

About this task

Attention

Procedure

Install the cross bar.
  1. Align the cross bar to the screw holes on the sides of tray; then, install the cross bar to the tray.
  2. Install five PH1 screws to secure the cross bar to the tray. Install two (2x) screws on each side, 1x screw on top, total of four (5x) screws.
    Note

    For reference, the torque required for the screws to be fully tightened/removed is 5.0+/- 0.5 in-lbs, 0.55+/- 0.056 N-m.

    Figure 1. Installing the cross bar

After you finish

  1. Install the tray cover. See Install the tray cover.

  2. Install the tray into the enclosure. See Install a tray in the enclosure.

  3. Connect all required external cables to the solution.
    Note
    Use extra force to connect QSFP cables to the solution.

  4. Check the power LED on each node to make sure it changes from fast blink to slow blink to indicate all nodes are ready to be powered on.