Skip to main content

Install the OSFP module cage

Use this information to install the OSFP module cage.

About this task

Attention

  • Read Installation Guidelines and Safety inspection checklist to ensure that you work safely.

  • Turn off the corresponding DWC tray that you are going to perform the task on.

  • Disconnect all external cables from the enclosure.

  • Use extra force to disconnect QSFP cables if they are connected to the solution.

Procedure

  1. Make preparations for this task.
  2. Assemble the OSFP module.
    1. Install the module bezel to the OSFP. Make sure the OSFP connectors are protruding through the openings on the bezel.
    2. Install two screws to secure the bezel to the OSFP.
    Figure 1. Assembling the OSFP module

After you finish

  1. Install the OSFP module. See Install the OSFP module.

  2. Complete cable routing. See Internal cable routing.

  3. Install the cross bar. See Install the cross bar.

  4. Install the tray cover. See Install the tray cover.

  5. Install the tray into the enclosure. See Install a tray in the enclosure.

  6. Connect all required external cables to the solution.
    Note
    Use extra force to connect QSFP cables to the solution.

  7. Check the power LED on each node to make sure it changes from fast blink to slow blink to indicate all nodes are ready to be powered on.