Install the rear wall

Use this information to install the rear wall.

Procedure

1. Slide the bus bar connector module into the slot on the tray rear wall. Install four screws from top and bottom to secure the bus bar connector module to the rear wall.
   Note

   For reference, the torque required for the screws to be fully tightened/removed is 5.0+/- 0.5 in-lbs, 0.55+/- 0.056 N-m.

   Figure 1. Installing the bus bar connector module
   
   
2. Install the system management sideband cable kit.
   1. Install the system management sideband cable kit into the opening on the rear wall.
   2. Install two (2x) M3 PH1 screws to secure the bottom of the sideband cable kit to the rear wall.
   3. Install the M3 PH1 screw (1x) from the top of the rear wall.
   Note

   • For reference, the torque required for the screws to be fully tightened/removed is 7.0 +/- 0.5 in-lbs, 0.79 +/- 0.056 N-m.

   • After installing all three screws, make sure the sideband cable kit is not entirely fixed to the rear wall. The sideband cable kit should be in floating position that allows slight movement.

   Figure 2. Installing system management sideband cable kit
   
   
3. Install the rear wall.
   1. Align the rear wall with the guide flanges on the tray. Then, install the rear wall to the tray.
   2. Install two screws on each side of the tray. Install total of four screws to secure the rear wall to the tray.
   Figure 3. Installing the rear wall
   
   
4. Insert the quick connects to the slots on the rear wall.
   Figure 4. Inserting quick connects to the rear wall
   
   
5. Install the T10 extension bit to the torque screwdriver; then, set the torque screwdriver to the proper torque, and install eight (8x) T10 screws to secure the quick connects to the rear wall.
   Note

   • For reference, the torque required for the screws to be fully tightened/removed is 5 +/- 0.5 in-lbs, or 0.56 +/- 0.056 N-m.

   • Installing the T10 extension bit to the torque screwdriver before installing the screws.

     Figure 5. T10 extension bit
     
     

   Figure 6. Installing the quick connect screws
   
   
6. Install four (4x) PH2 screws to secure the bus bar connector module to the P48V bus bar in the tray.
   Note

   For reference, the torque required for the screws to be fully tightened/removed is 15 +/-0.5 in-lbs, or 1.69 +/- 0.056 N-m.

   Figure 7. Installing the bus bar connector module