Install the bus bar connector module
Use this information to install the bus bar connector module.
About this task
Screwdriver for PH1 and PH2 screws
Read Installation Guidelines and Safety inspection checklist to ensure that you work safely.
The following illustration might differ slightly from your hardware, but the installation method is the same.
Go to Drivers and Software download website for ThinkSystem SC777 V4 to see the latest firmware and driver updates for your server.
Go to Update the firmware for more information on firmware updating tools.
Procedure
- Slide the bus bar connector module into the slot on the tray rear wall. Install four screws from top and bottom to secure the bus bar connector module to the rear wall.Note
For reference, the torque required for the screws to be fully tightened/removed is 5.0+/- 0.5 in-lbs, 0.55+/- 0.056 N-m.
Figure 1. Installing the bus bar connector module
- Arrange the bus bar connector module cables until the cables are neatly seated next to each other, and the surface of this bundle of cables is flat. Figure 2. Bus bar connector module cables arrangement
- Secure the bus bar connector cables with the cable tie on the NVLink interposer board stiffener.Figure 3. Securing the bus bar connector cables with cable tie
Complete cable routing. See Internal cable routing.
Install the cross bar. See Install the cross bar.
Install the tray cover. See Install the tray cover.
Install the tray into the enclosure. See Install a tray in the enclosure.
- Connect all required external cables to the solution.NoteUse extra force to connect QSFP cables to the solution.
Check the power LED on each node to make sure it changes from fast blink to slow blink to indicate all nodes are ready to be powered on.