Install the leakage sensor

Use this information to install the leakage sensor.

Procedure

1. Install the leakage sensor to the leakage sensor bracket on the tray.
   Note

   Keep the side with LED light facing up.

   Figure 1. Installing leakage sensor
   
   
2. Route the leakage sensor cable as shown in the illustration below. Cable-retaining Mylar tabs are attached to the side wall of the tray. Open the cable-retaining tabs; then, insert the leakage sensor cable into the tabs.
   Figure 2. Inserting leakage sensor cable to the cable-retaining tabs
   
   

   Note

   The leakage sensor cable should be inserted into each cable-retaining tab as shown in the illustration below.

   Figure 3. Leakage sensor module inserted into the cable-retaining tabs
   
   
3. Connect the leakage sensor to the host board. Insert the leakage sensor cable to the cable clip.
   Figure 4. Connecting leakage sensor to the host board