Skip to main content

Install the tray hex screws

Use this information to install the tray hex screws.

About this task

Attention
Firmware and driver download: You might need to update the firmware or driver after replacing a component.

Procedure

  1. If the E3.S switch board is installed, remove it from the tray. See Remove the E3.S switch board.
  2. With a flat head screwdriver, install five hex screws to the tray.
    Figure 1. Installing the hex screws to the tray

After you finish

  1. Install the water loop. See Install the water loop.

  2. Install the E3.S drive cage. See Install an E3.S drive cage assembly.

  3. Install the PCIe adapter riser cage. See Install a ConnectX-7 NDR 200 adapter riser assembly, Install a ConnectX-7 NDR 400 adapter riser assembly, Install a ConnectX-8 XDR adapter riser assembly, or Install the OSFP module.

  4. Install the cross bar. See Install the cross bar.

  5. Install the tray cover. See Install the tray cover.

  6. Install the tray into the enclosure. See Install a tray in the enclosure.

  7. Connect all required external cables to the solution.
    Note
    Use extra force to connect QSFP cables to the solution.

  8. Check the power LED on each node to make sure it changes from fast blink to slow blink to indicate all nodes are ready to be powered on.