Skip to main content

Remove the cross bar

Use this information to remove the cross bar.

About this task

Attention

  • Read Installation Guidelines and Safety inspection checklist to ensure that you work safely.

  • Turn off the corresponding DWC tray that you are going to perform the task on.

  • Disconnect all external cables from the enclosure.

  • Use extra force to disconnect QSFP cables if they are connected to the solution.

Watch the procedure
  • A video of this procedure is available at YouTube.

Procedure

  1. Make preparations for this task.
    1. Remove the tray cover. See Remove the tray cover.
  2. Remove the cross bar.
    1. Remove five (5x) screws to release the cross bar from the tray (2x screws on each side, 1x screw on top, 5x screws in total).
    2. Remove the cross bar.
    Figure 1. Removing the cross bar

After you finish

If you are instructed to return the component or optional device, follow all packaging instructions, and use any packaging materials for shipping that are supplied to you.