Remove E3.S 1T dual front drive

Use this information to remove E3.S 1T dual front drives.

Procedure

1. Make preparations for this task.
   1. Remove the tray from the enclosure. See Remove a tray from the enclosure.
   2. Remove the tray cover. See Remove the tray cover.
   3. Remove the cross bar. See Remove the cross bar.
   4. Remove the E3.S drive cages. see Remove an E3.S front drive cage assembly.
   Attention

   Removal procedures listed in this section do NOT apply to drive 2/3, drive 4/5, drive 6/7, or drive 8/9 in Dual CX8 mezzanine module configuration. To install drives in said configuration, refer to Remove E3.S 1T dual front drive (Drive 2/3 to 8/9 in Dual CX8 Configuration).

2. Remove two PH1 screws to remove the side holder.
   Figure 1. Removing the side holder
   
   
3. Remove two PH1 screws to remove the drive cage bezel from the drive cage.
   Figure 2. Removing drive cage bezel
   
   
4. Disconnect the cables from the drives.
   Figure 3. Disconnecting cables from drives
   
   
5. Remove four screws to release the drive from the drive cage.
   Figure 4. Removing drives from the drive cage
   
   
6. Remove the heat sink.
   1. Rotate the heat sink until it is positioned at an angle.
   2. Remove the heat sink from the drive cage.
      Figure 5. Removing the heat sink
      
      
7. Remove the drive from the drive cage.
   
   
   
8. Remove the drive.
   
   
   
9. Remove four screws to release the drive from the drive cage.
   Figure 6. Removing drives from the drive cage
   
   
10. Remove the drive from the drive cage.