Skip to main content

Remove an E3.S front drive cage assembly

Use this information to remove an E3.S front drive cage assembly.

About this task

Required tools

  • E3.S drive cage heat pipe gap pad

  • E3.S drive cage bottom pad

Attention

  • Read Installation Guidelines and Safety inspection checklist to ensure that you work safely.

  • Turn off the corresponding DWC tray that you are going to perform the task on.

  • Disconnect all external cables from the enclosure.

  • Use extra force to disconnect QSFP cables if they are connected to the solution.

  • The following illustration might differ slightly from your hardware, but the installation method is the same.

Watch the procedure
  • A video of this procedure is available at YouTube.

Procedure

  1. Make preparations for this task.
    1. Remove the tray from the enclosure. See Remove a tray from the enclosure.
    2. Remove the tray cover. See Remove the tray cover.
    3. Remove the cross bar. See Remove the cross bar.
  2. Remove the blank filler from the slot installed with the drive cage.
    Figure 1. Removing blank bezel filler
    Blank bezel filler removal
  3. Disconnect the cables from the system board.
  4. Remove the E3.S front drive cage assembly.
    1. Loosen three captive screws.
    2. Remove the E3.S front drive cage assembly.
    Figure 2. Removing E3.S front drive cage assembly
    E3.S drive cage assembly removal
After you finish

If you are instructed to return the component or optional device, follow all packaging instructions, and use any packaging materials for shipping that are supplied to you.

If necessary, remove the putty pads from the water loop.
Figure 3. Removing putty pads