Skip to main content

Remove the tray rubber

Use this information to remove the tray rubber.

About this task

Attention

  • Read Installation Guidelines and Safety inspection checklist to ensure that you work safely.

  • Turn off the corresponding DWC tray that you are going to perform the task on.

  • Disconnect all external cables from the enclosure.

  • Use extra force to disconnect QSFP cables if they are connected to the solution.

  • To avoid damaging the water loop, always use the water loop carrier when removing, installing or folding the water loop.

  • The following illustration might differ slightly from your hardware, but the removal method is the same.

Watch the procedure
  • A video of this procedure is available at YouTube.

Procedure

  1. Make preparations for this task.
    1. Remove the tray from the enclosure. See Remove a tray from the enclosure.
    2. Remove the tray cover. See Remove the tray cover.
    3. Remove the cross bar. See Remove the cross bar.
    4. Remove the bus bar connector module. See Remove the bus bar connector module.
    5. Remove the PCIe adapter riser assembly. See Remove a ConnectX-7 NDR 200 adapter riser assembly, Remove a ConnectX-7 NDR 400 adapter riser assembly, Remove a ConnectX-8 XDR adapter riser assembly, or Remove the OSFP module.
    6. Remove the E3.S drive cages. see Remove an E3.S front drive cage assembly.
    7. Remove the water loop from the tray. See Remove the water loop.
    8. Remove the P48V bus bar. See Remove the P48V bus bar.
  2. Remove the tray rubber from the Mylar on the right-side rear corner in the tray.
    Figure 1. Removing the tray rubber

After you finish

If you are instructed to return the component or optional device, follow all packaging instructions, and use any packaging materials for shipping that are supplied to you.