Skip to main content

Remove the OCP 3.0 module

Follow instructions in this section to remove the OCP 3.0 module.

About this task

CAUTION
Power off the server and disconnect all power cords from their power sources before performing this procedure.
Attention

  • Read Installation Guidelines and Safety inspection checklist to ensure that you work safely.

  • Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-sensitive components in their static-protective packages until installation, and handling these devices with an electrostatic-discharge wrist strap or other grounding system.

Watch the procedure
  • A video of this procedure is available at YouTube.

Procedure

  1. Remove the OCP 3.0 module.
    Figure 1. Removing the OCP 3.0 module
    Removing the OCP 3.0 module

    1. Loosen the thumbscrew that secures the card.
    2. Pull out the OCP 3.0 module.
  2. (Optional) Remove the OCP label.
    Figure 2. Removing the OCP label
    Removing the OCP label

After you finish

  1. Install a new OCP 3.0 module or a card filler.

  2. If you are instructed to return the component or optional device, follow all packaging instructions, and use any packaging materials for shipping that are supplied to you.