Skip to main content

Removing the system-board assembly

Use this information to remove the system-board assembly.

Note
This procedure should be performed only by trained service technicians.
Before you remove the system-board assembly, complete the following steps:
  1. Read Safety and Installation guidelines.
  2. If the compute node is installed in a chassis, remove it (see Removing a compute node from a chassis for instructions).
  3. Carefully lay the compute node on a flat, static-protective surface, orienting the compute node with the bezel pointing toward you.
  4. Obtain the following for use during the replacement procedure (see Parts listing, Types 7162 and 2588).
    • Alcohol wipes
    • Thermal grease
    • RFID tag (required only if the compute node came with a RFID tag attached to the bezel)
Important
When you replace the system board, you must update the compute node with the latest firmware or restore the preexisting firmware. Make sure that you have the latest firmware or a copy of the preexisting firmware before you proceed. See Updating firmware and device drivers for more information.

See System-board layouts for more information about the locations of the connectors, jumpers, and LEDs on the system board.

If you are instructed to return the system-board assembly, follow all packaging instructions, and use any packaging materials for shipping that are supplied to you.