Enabling virus scanning on an SVM

You must enable virus scanning on an SVM before an on-access or on-demand scan can run. The Vscan configuration must exist.

1. Enable virus scanning on an SVM: vserver vscan enable -vserver data_SVM
   Note

   You can use the vserver vscan disable command to disable virus scanning if necessary.

   Example

   The following command enables virus scanning on the vs1 SVM:

   cluster1::> vserver vscan enable -vserver vs1
   
2. Verify that virus scanning is enabled on the SVM: vserver vscan show -vserver data_SVM

   For a complete list of options, see the man page for the command.

   Example

   The following command displays the Vscan status of the vs1 SVM:

   cluster1::> vserver vscan show -vserver vs1
   
                              Vserver: vs1
                         Vscan Status: on