Fault LED is lit
Use this procedure if the fault LED on the power module is lit.
Problem
The fault LED for the power module is lit.
Investigation
Perform these steps to resolve the problem:
Note
Before unplugging the AC power cord from the power module or removing the power module from the BladeCenter S chassis, verify that the capacity of the remaining power modules are sufficient to meet the minimum power requirements for all components in the BladeCenter S chassis. You can view power status and requirements through the advanced management module.
For information on accessing and using the advanced management module, see the Advanced Management Module User's Guide .
- Verify that the power modules are properly connected to an AC power source. All power modules in the BladeCenter S chassis must be connected to the same power input voltage (either 110 V ac or 220 V ac). Do not mix power input voltages.
- Unplug the AC power cord from the power module and plug it in again.
- Reseat the power supply.
- Swap the AC power cord with a power cord that is known to be working.
- Move the power module to another power module bay in the BladeCenter S chassis.
Give documentation feedback