Skip to main content

metrocluster configuration-settings dr-group delete

Delete a DR group in a MetroCluster setup

Availability: This command is available to cluster administrators at the admin privilege level.

Description​

The metrocluster configuration-settings dr-group delete command deletes a DR group and its node partnerships that were configured using the metrocluster configuration-settings dr-group create command.

This command cannot be run if the metrocluster configuration-settings interface create command has configured a network logical interface on a network port provisioned for MetroCluster. The metrocluster configuration-settings interface delete command must then be run to delete the network logical interfaces on every node in the DR group.

The metrocluster configuration-settings commands commands are run in the following order to remove the MetroCluster over IP configuration:

Parameters​

-dr-group-id <integer> - Dr group Id
This parameter indentifies the DR group to be deleted.

Examples​

The following example shows the deletion of the MetroCluster DR group: 

clusA:: metrocluster configuration-settings dr-group delete -dr-group-id 1

Warning: This command deletes the existing DR group relationship. Are you sure
         you want to proceed ? [y|n]: y
[Job 279] Job succeeded: DR Group Delete is successful.

clusA::  metrocluster configuration-settings dr-group  show
No DR groups exist.

clusA:: metrocluster configuration-settings show-status
Cluster                    Node               Configuration Settings Status
-------------------------- ------------------ ---------------------------------
clusA
                           A1                 ready for DR group create
                           A2                 ready for DR group create
clusB
                           B1                 ready for DR group create
                           B2                 ready for DR group create
4 entries were displayed.