Skip to main content

406-903-000 : IANet:Interrupts Test Failed

IANet:Interrupts Test Failed

Severity​

Error

Serviceable​

Yes

Recoverable​

No

Automatically Notify Support​

No

User Action​

Complete the following steps:

  1. Check component firmware level and upgrade if necessary. The installed firmware level can be found in the DSA Diagnostic Event Log within the Firmware/VPD section for this component.
  2. Rerun the test.
  3. Check interrupt assignments in the PCI Hardware section of the DSA Diagnostic Log. If the ethernet device is sharing interrupts, if possible modify the interrupt assignments using F1 Setup to assign a unique interrupt to the device.
  4. Rerun the test.
  5. If failure remains, refer to "Troubleshooting by symptom" in the system "Installation and Service Guide" for the next corrective action.