Verifying and setting the HA state of the chassis

You must verify the HA state of the chassis, and, if necessary, update the state to match your system configuration.

From the LOADER prompt, enter Maintenance mode by typing boot_maint.
In Maintenance mode, from either controller module, display the HA state of the local controller module and chassis: ha-config show
The HA state should be the same for all components.
If the displayed system state for the chassis does not match your system configuration:
1. Set the HA state for the chassis: ha-config modify chassis HA-state
  The value for HA-state can be one of the following:
  - ha
  - mcc
  - mcc-2n
  - non-ha
2. Confirm that the setting has changed: ha-config show
If you have not already done so, recable the rest of your system.

Give feedback