Configuring the ports

To configure the unified target adapter (4XC7A14394), you must configure the two adjacent ports on the same chip in the same personality mode.

1. Configure the ports as needed for Fibre Channel (FC) or Converged Network Adapter (CNA) using the system node hardware unified-connect modify command.
2. Attach the appropriate cables for FC or 10 Gb Ethernet.
3. Verify that you have the correct SFP+ installed:network fcp adapter show -instance -node -adapter

   For CNA, you should use a 10Gb Ethernet SFP. For FC, you should either use an 8 Gb SFP or a 16 Gb SFP, based on the FC fabric being connected to.