Install the cross braces (SD650 V3)
Use this information to install the cross braces.
About this task
Attention
Read Installation Guidelines and Safety inspection checklist to ensure that you work safely.
Watch the procedure
- A video of this procedure is available at YouTube.
Procedure
Install the front and the rear cross braces (14x Phillips #1 screws).
Figure 1. Cross brace installation (SD650 V3)
After you finish
Install the tray cover. See Install the tray cover.
Install the tray into the enclosure. See Install a DWC tray in the enclosure.
- Connect all required external cables to the solution.NoteUse extra force to connect QSFP cables to the solution.
Check the power LED on each node to make sure it changes from fast blink to slow blink to indicate all nodes are ready to be powered on.
Give documentation feedback