Skip to main content

Parts list

Use the parts list to identify each of the components that are available for your solution.

For more information about ordering parts:
  1. Go to Lenovo Data Center Support and navigate to the support page for your solution.

  2. Click Parts.

  3. Enter the serial number to view a listing of parts for your solution.

It is highly recommended that you check the power summary data for your solution using Lenovo Capacity Planner before purchasing any new parts.

Note
Depending on the model, your solution might look slightly different from the illustration.
The parts listed in the following table are identified as one of the following:
  • Tier 1 customer replaceable unit (CRU): Replacement of Tier 1 CRUs is your responsibility. If Lenovo installs a Tier 1 CRU at your request with no service agreement, you will be charged for the installation.

  • Tier 2 customer replaceable unit (CRU): You may install a Tier 2 CRU yourself or request Lenovo to install it, at no additional charge, under the type of warranty service that is designated for your solution.

  • Field replaceable unit (FRU): FRUs must be installed only by trained service technicians.

  • Consumable and Structural parts: Purchase and replacement of consumable and structural parts (components, such as a cover or bezel) is your responsibility. If Lenovo acquires or installs a structural component at your request, you will be charged for the service.

SD650 V3 parts list

Figure 1. SD650 V3 parts list
SD650 V3 parts list
Table 1. SD650 V3 parts list
IndexDescriptionTier 1 CRUTier 2 CRUFRUConsumable and Structural part
For more information about ordering parts:
  1. Go to Lenovo Data Center Support and navigate to the support page for your solution.

  2. Click Parts.

  3. Enter the serial number to view a listing of parts for your solution.

1Tray cover   
2Rear cross brace   
3Power distribution board   
4Water loop   
5DIMM comb   
6DIMM tool   
7Memory module   
8Memory module filler   
9VR water clamp plate   
10VR water loop trough   
11System board   
12Processor   
13Processor retainer   
14PCIe adapter kit   
15PCIe adapter   
16PCIe riser cage   
17Drive cage   
18Upper Drive Conduction Plate   
192.5-inch drive (15 mm)   
202.5-inch drive (7 mm)   
21Front cross brace   
22SD650 V3 cam handles   
23Blank bezel filler   
24KVM cover   
25M.2 drive (80 mm and 110 mm)   
26M.2 backplane assembly   
27CMOS battery (CR2032)   
28Cable   
29SD650 V3 tray   
30Water loop carrier   
31Gap pad kit   
32Miscellaneous Parts Kit   
33SD650 V3 water loop Service Kit