Install the RAID adapter

Use this information to install the RAID adapter in the RAID adapter slot on the system board.

Read the installation Guidelines

Power off the server for this task

ATTENTION: Static Sensitive Device Ground package before opening

Ensure that you follow the installation order if you install more than one RAID adapter:

• The RAID adapter slot on the system board

• The PCIe slot 4 on the system board if the serial port module is not installed

• A PCIe slot on the riser card

Note

The following procedure is based on the scenario that the RAID adapter will be installed in the RAID adapter slot on the system board. For the procedure about installing the RAID adapter in PCIe slot 4 or a PCIe slot on the riser assembly, see Install a PCIe adapter.

Before installing the RAID adapter:

1. Touch the static-protective package that contains the new RAID adapter to any unpainted surface on the outside of the server. Then, take the new RAID adapter out of the package and place it on a static-protective surface.

2. If the RAID adapter is installed with a bracket, remove the bracket.

To install the RAID adapter in the RAID adapter slot on the system board, complete the following steps:

Watch the procedure

A video of this procedure is available at YouTube.

Figure 1. RAID adapter installation

1. Place the RAID adapter into the slot at an angle.
2. Rotate the RAID adapter down.
3. Push the right-side latch open.
4. Push the RAID adapter to the fully horizontal position and insert it into the RAID adapter slot.
5. Slide the left-side latch to the locked position.