Skip to main content

Install the CMOS battery - CR2032

Use this procedure to install the CMOS battery.

Consider the following notes when replacing the CMOS battery in the server:

  • When replacing the CMOS battery, you must replace it with another CMOS battery of the same type from the same manufacturer.
  • After you replace the CMOS battery, you must reconfigure the server and reset the system date and time.
  • To avoid possible danger, read and follow the following safety statement.
S002
disconnect all power
CAUTION
The power-control button on the device and the power switch on the power supply do not turn off the electrical current supplied to the device. The device also might have more than one power cord. To remove all electrical current from the device, ensure that all power cords are disconnected from the power source.
S004
Attention
CAUTION

When replacing the lithium battery, use only Lenovo specified part number or an equivalent type battery recommended by the manufacturer. If your system has a module containing a lithium battery, replace it only with the same module type made by the same manufacturer. The battery contains lithium and can explode if not properly used, handled, or disposed of.

Do not:
  • Throw or immerse into water
  • Heat to more than 100°C (212°F)
  • Repair or disassemble

Dispose of the battery as required by local ordinances or regulations.

S005
Attention
CAUTION
The battery is a lithium ion battery. To avoid possible explosion, do not burn the battery. Exchange it only with the approved part. Recycle or discard the battery as instructed by local regulations.

Before installing the CMOS battery:

  1. Read the safety information and installation guidelines (see Safety and Installation Guidelines).

  2. Touch the static-protective package that contains the component to any unpainted metal surface on the server; then, remove it from the package and place it on a static-protective surface.

To install the CMOS battery, complete the following steps:

  1. Follow any special handling and installation instructions that come with the replacement battery.
  2. Face the positive (+) symbol to the center of the server; then, place the battery into the seat until it clicks in place.
    Figure 1. CMOS battery installation

After installing the CMOS battery, complete the following steps:

  1. Reinstall the system board air baffle (see Install the system board air baffle and the power interposer) or processor and memory expansion tray and processor and memory expansion tray air baffle (see Install the processor and memory expansion tray).

  2. Install the PCIe expansion tray (see Install the PCIe expansion tray).

  3. Install the top cover (see Install the top cover).

  4. Reconnect the power cords and any cables that you removed.

  5. If the server is installed in a rack, reinstall the server into the rack.

  6. Power on the server and any peripheral devices.

Demo video

Watch the procedure on YouTube