Database commands
- Clear storage array configuration
The clear storageArray configuration command clears an entire storage array configuration or part of a storage array configuration, or clears volume group and volume configuration only. - Clear storage array recovery mode
The clear storageArray recoveryMode command forces a storage array to exit recovery mode. - Load storage array DBM database
The load storageArray command restores a Database Management (DBM) database image by retrieving the image from a file or from cache. - Save storage array DBM database
The save storageArray dbmDatabase command backs up RAID configuration data or all data to a file on the host. You can specify multiple data locations and controllers. - Save storage array DBM validator information file
The save storageArray dbmValidatorInfo command saves the database management (DBM) validation information for a storage array in an XML file. - Show storage array DBM database
The show storageArray dbmDatabase command retrieves and shows metadata for the on-board backup locations of a storage array. When there are multiple backup locations, metadata is shown for each location. - Start storage array configuration database diagnostic
The start storageArray configDbDiagnostic command runs a consistency check against a configuration database. - Stop storage array configuration database diagnostic
The stop storageArray configDbDiagnostic command stops the diagnostic test to validate the configuration database in the controller firmware that was started by the start storageArray configDbDiagnostic command.
Give documentation feedback