Skip to main content

Controller host port configuration commands

  • Create host port
    The create hostPort command creates a new host port identification on a host bus adapter (HBA).
  • Create initiator
    The create initiator command creates the initiator object.
  • Delete initiator
    The delete initiator command deletes the initiator object.
  • Set initiator
    The set initiator command updates the initiator object.
  • Reset storage array host port statistics baseline
    The reset storageArray hostPortStatisticsBaseline command resets the storage array host port statistics baseline.
  • Save storage array host port statistics
    The save storageArray hostPortStatistics command saves the storage array host port statistics.
  • Set controller host port properties
    The set controller hostPort command changes the network properties for the following types of host ports: iSCSI and NVMe over RoCE. Property changes include IPv4 and IPv6 properties, port speed, and maximum frame payload.
  • Set target properties
    The set target command changes the properties for an iSCSI target, including authentication method and alias name.
  • Set iSCSI host port networking properties
    The set controller iscsiHostPort command changes the network properties for a host port, including IPv4 and IPv6 properties, port speed, and maximum frame payload.
  • Set iSCSI initiator
    The set iscsiInitiator command sets the attributes for an iSCSI initiator.
  • Show storage array unconfigured iSCSI initiators
    The show storageArray unconfiguredIscsiInitiators command returns a list of initiators that have been detected by the storage array but are not yet configured into the storage array topology.
  • Show unconfigured initiators
    The show storageArray unconfiguredInitiators command returns a list of initiators that have been detected by the storage array but are not yet configured into the storage array topology.