Skip to main content

iSCSI Express Setup

  1. Verify the Linux configuration is supported
    To ensure reliable operation, you create an implementation plan and then verify that the entire configuration is supported.
  2. Configure IP addresses using DHCP
    In this express method for configuring communications between the management station and the storage array, you use Dynamic Host Configuration Protocol (DHCP) to provide IP addresses. Each controller has two storage management ports, and each management port will be assigned an IP address.
  3. Install and configure Host Utilities
    Linux Unified Host Utilities 7.1 includes tools to manage Lenovo storage, including failover policies and physical paths.
  4. Install ThinkSystem Storage Manager for Host Utilities
    When you install the ThinkSystem Storage Manager software on your management station, the Host Context Agent is installed that helps the host push configuration information to the storage array controllers through the I/O path. For the 11.60.2 release, Storage Manager (Host Utilities) can only be installed on host servers. All multi-system management functions have been moved to SAN Manager.
  5. Access ThinkSystem System Manager and use the Setup wizard
    You use the Setup wizard in ThinkSystem System Manager to configure your storage array.
  6. Configure the multipath software
    Multipath software provides a redundant path to the storage array in case one of the physical paths is disrupted. The multipath software presents the operating system with a single virtual device that represents the active physical paths to the storage. The multipath software also manages the failover process that updates the virtual device. You use the device mapper multipath (DM-MP) tool for Linux installations.
  7. Setting up the multipath.conf file
    The multipath.conf file is the configuration file for the multipath daemon, multipathd. The multipath.conf file overrides the built-in configuration table for multipathd. Any line in the file whose first non-white-space character is # is considered a comment line. Empty lines are ignored.
  8. Configure the switches
    You configure the switches according to the vendor’s recommendations for iSCSI. These recommendations might include both configuration directives as well as code updates.