Skip to main content

Configuring the NVMe/FC switches

Configuring (zoning) the NVMe over Fibre Channel (FC) switches enables the hosts to connect to the storage array and limits the number of paths. You zone the switches using the management interface for the switches.

  • You must have administrator credentials for the switches.
  • You must have used your HBA utility to discover the WWPN of each host initiator port and of each controller target port connected to the switch.
Note
A vendor's HBA utility can be used to upgrade and obtain specific information about the HBA. Refer to the support section of the vendor's website for instructions on how to obtain the HBA utility.

For details about zoning your switches, see the switch vendor's documentation.

Each initiator port must be in a separate zone with all of its corresponding target ports.

  1. Log in to the FC switch administration program, and then select the zoning configuration option.
  2. Create a new zone that includes the first host initiator port and that also includes all of the target ports that connect to the same FC switch as the initiator.
  3. Create additional zones for each FC host initiator port in the switch.
  4. Save the zones, and then activate the new zoning configuration.