Skip to main content

Network Settings

Attention
Clicking “Save Network Settings” at the bottom of this page is required to save changes on this page and subpage.
Table 1. Network Settings
ItemOptionsDescription
Network Interface Port

  • Dedicated

  • Shared

Selects System Management Network Interface Port.

Shared NIC on

OCP Card

Selects shared NIC port.

Note

  • This feature appears only when Network Interface Port is set to [Shared].

  • SR250 V3, ST50 V3 and ST250 V3 do not support this function.

Fail-Over Rule

  • None

  • Failover to shared (Optional Card ML2)

  • Failover to shared (Optional Card PHY)

  • Failover to shared (Onboard Port)

Controls fail-over types allowed.

Note
This feature appears only when Network Interface Port is set to [Dedicated].
Network Setting

  • Synchronization

  • Independence

The feature is selectable only when Fail-Over Rule is enabled to onboard port or optional card.

Note
SR250 V3, ST50 V3 and ST250 V3 do not support this function.
Burned-in MAC Address

N/A

Displays MAC addresses from the network interface controller.

Hostname

N/A

Changes host name. The length must be within 1 to 63 characters.

DHCP Control

  • Static IP

  • DHCP Enabled

  • DHCP with Fallback

Configures DHCP Control or configure a staic IP address manually.

Fallback uses static IP address if DHCP fails.

Select [Static IP] to enter IPV4 address manually.

IP Address

x.x.x.x

Enters IP Address in dotted-decimal notation.

Subnet Mask

x.x.x.x

Enters Subnet Mask in dotted-decimal notation.

Default Gateway

x.x.x.x

Enters Default Gateway in dotted-decimal notation.

IPv6

  • Enabled

  • Disabled

Enables or disables IPv6 support on management port.

Note
This feature is unable to reset to default value by using the load default in Setup.
Local Link Address

N/A

Displays local link address.

VLAN Support

  • Enabled

  • Disabled

Enables or disables VLAN Support to specify the 802.1q VLAN ID on the management port network device.

Note
This feature is unable to reset to default value by using the load default in Setup.
VLAN ID

1

VLAN ID Range is 1 to 4094.

Note
This feature appears only when VLAN Support is enabled.
Advanced Settings for BMC Ethernet

N/A

Provides advanced settings for BMC Ethernet.

Save Network Settings

N/A

Saves changes in BMC.