Skip to main content

Monitor or video problems

Use this information to diagnose and resolve monitor or video errors.

Follow the suggested actions in the order in which they are listed in the Action column until the problem is solved.

The video monitor is a shared BladeCenter unit resource. First, make sure that the video monitor is assigned to the blade server; then, see the following table and Solving shared BladeCenter resource problems.

  • See Parts listing, Types 8014, 8028 and 1916 to determine which components are CRUs and which components are FRUs.
  • If an action step is preceded by "(Trained service technician only)," that step must be performed only by a trained service technician.
SymptomAction
The screen is blank.
  1. Check the function of the shared BladeCenter unit resources (see Solving shared BladeCenter resource problems).
  2. Make sure that:
    • Damaged BIOS code is not affecting the video; see Recovering from a BIOS update failure.
      Important
      In some memory configurations, the 3-3-3 beep code might sound during POST, followed by a blank monitor screen. If this occurs and the Boot Fail Count option in the Start Options of the Configuration/Setup Utility program is enabled, you must restart the blade server three times to reset the configuration settings to the default configuration (the memory connector or band of connectors enabled).
    • The device drivers are installed correctly.
  3. (Trained service technician only) Replace the system-board assembly
The monitor has screen jitter, or the screen image is wavy, unreadable, rolling, or distorted.
  1. Check the function of the shared BladeCenter unit resources (see Solving shared BladeCenter resource problems).
  2. (Trained service technician only) Replace the system-board assembly.
Wrong characters appear on the screen.
  1. If the wrong language is displayed, update the firmware or operating system with the correct language in the blade server that has ownership of the monitor.
  2. Check the function of the shared BladeCenter unit resources (see Solving shared BladeCenter resource problems).
  3. (Trained service technician only) Replace the system-board assembly.