Performing the checkout procedure
Use this information to perform the checkout procedure for the blade server.
To perform the checkout procedure, complete the following steps:
- If the blade server is running, turn off the blade server.
- Turn on the blade server. Make sure that the blade server has control of the video (the LED on the keyboard/video/mouse button is lit). If the blade server does not start, see Troubleshooting tables.
- Record any POST beep codes that sound or POST error messages that are displayed on the monitor. If an error is displayed, look up the first error in the POST error codes.
- Check the control panel blade-error LED; if it is lit, check the light path diagnostics LEDs (see Light path diagnostics).
- Check for the following results:
- Successful completion of POST, indicated by a single beep.
- Successful completion of startup, indicated by a readable display of the operating-system desktop.
- Did a single beep sound and are there readable instructions on the main menu?
- No: Find the failure symptom in Troubleshooting tables; if necessary, see Solving undetermined problems.
- Yes: Run the diagnostic programs (see Diagnostics).
- If you receive an error, see Diagnostic messages.
- If the diagnostic programs were completed successfully and you still suspect a problem, see Solving undetermined problems.
Give feedback