Skip to main content

Solving undetermined problems

If Lenovo ThinkServer Diagnostics Tool cannot diagnose the failure or if the server is inoperative, use the information in this section to solve the undetermined problems.

If you suspect that a software problem is causing failures (continuous or intermittent), see Software problems.

Corrupted data in CMOS memory or corrupted UEFI firmware could prevent the system from completing POST or lead to no screen output after power on. To reset the CMOS data, use the CMOS clear jumper to clear the CMOS memory and override the power-on password; see System-board internal connectors for more information. If you suspect that the UEFI firmware is corrupted, see Recovering the server firmware (UEFI update failure).

If the power supplies are working correctly, complete the following steps:

  1. Turn off the server.
  2. Make sure that the server is cabled correctly.
  3. Remove or disconnect the following devices, one at a time, until you find the failure. Turn on the server and reconfigure it each time.
    • Any external devices.
    • Surge-suppressor device (on the server).
    • Printer, mouse, and non-Lenovo devices.
    • Each adapter.
    • Hard disk drives.
    Note
    The minimum configuration required for the server to start is one microprocessor and one 8 GB DIMM.
  4. Turn on the server. If the problem remains, suspect the following components in the following order:
    1. Power supply
    2. Memory
    3. Microprocessor
    4. System board

If the problem is solved when you remove an adapter from the server but the problem recurs when you reinstall the same adapter, suspect the adapter; if the problem recurs when you replace the adapter with a different one, suspect the riser card.

If you suspect a networking problem and the server passes all the system tests, suspect a network cabling problem that is external to the server.