Rail and supported rack specifications
| Option name | System x Gen II Universal Slides Kit |
| Option part number | 00KA500 |
| Rail type | Full-out slide rail (ball bearing) |
| Supported rack type | Any four-post rack, complying with the IEC standard If a 0U PDU is to be installed, read the notes at the bottom. |
| Service on rack | Yes |
| Cable management arm (CMA) support | Yes |
| 1U PDU support | Yes |
| 0U PDU support | Limited support. Read the notes at the bottom. |
| Mounting holes | Square, round, or threaded |
| Thickness of mounting flanges | 2 mm (0.08 inch) – 4.65 mm (0.18 inch) |
| Distance between front and rear mounting flanges | 617 mm (24.29 inches) – 812 mm (31.97 inches) |
| Rail length (measured when mounted on the rack, starting from the front surface of the front mounting flange to the rear most point of the rail) | 836.8 mm (32.94 inches) |
Note
- If you want to install the rails and a 0U PDU into the same rack, the rack must meet the following height and depth requirements:
42U or higher
At least 1100-mm (43.31-inch) deep if no CMA is to be installed; at least 1200-mm (47.24-inch) deep if a CMA is to be installed
The option part numbers might change.
Give documentation feedback