Skip to main content

Install the EIA brackets to the chassis

Follow instructions in this section to install the EIA brackets to the chassis.

About this task

To avoid potential danger, make sure to read and follow the safety information.

Attention

Read Installation Guidelines and Safety inspection checklist to make sure that you work safely.

Procedure

Align the left EIA bracket with the screw holes on the left of the chassis; then, secure it to the chassis with the screws.
Repeat the same step to secure the right EIA bracket to the right of the chassis.
Figure 1. Installation of the EIA brackets

After you finish

Install the chassis to the rack (see Install the chassis to the rack).
Reinstall each PSU slot with a PSU or PSU filler (see Install a hot-swap power supply and Installation of a PSU filler).
Reinstall the nodes into the chassis.
For the procedures of installing a specific node, see the links below:
- SD520 V4: Install a node to the chassis

Demo video

Watch the procedure on YouTube

Give documentation feedback