Skip to main content

Moving the power supplies

You must move the power supplies from the impaired controller module to the replacement controller module when you replace a controller module.

A video for this task is available at:
  1. Rotate the cam handle such that it can be used to pull power supply out of the controller module while pressing the locking tab.
    CAUTION
    The power supply is short. Always use two hands to support it when removing it from the controller module so that it does not suddenly swing free from the controller module and injure you.


    Blue power supply locking tab
    Power supply
  2. Move the power supply to the new controller module, and then install it.
  3. Using both hands, support and align the edges of the power supply with the opening in the controller module, and then gently push the power supply into the controller module until the locking tab clicks into place.
    The power supplies will only properly engage with the internal connector and lock in place one way.
    Attention
    To avoid damaging the internal connector, do not use excessive force when sliding the power supply into the system.
  4. Repeat the preceding steps for any remaining power supplies.