Skip to main content

Moving the boot media

There is one boot media device in the DG5000 under the air duct in the controller module. You must move it from the impaired controller module to the replacement controller module.

You need a #1 magnetic Phillips head screw driver to remove the screw that holds the boot media in-place. Due to the space constraints within the controller module, you should also have a magnet to transfer the screw on to so that you do not lose it.

A video for this task is available at:
  1. Locate the boot media from the impaired controller module to the replacement controller module.
  2. Use either your thumb or a Phillips head screwdriver to loosen the screw on the right of the boot media until the device comes free.
  3. Gently lift the boot media directly out of the socket and align it into place in the replacement controller module.
  4. Use the screwdriver or your thumb to tighten the screw on the boot media.