Skip to main content

Moving the boot media

You must locate the boot media and follow the directions to remove it from the old controller module and insert it in the new controller module.

About this task

A video for this task is available at:
  1. Locate the boot media using the following illustration or the FRU map on the controller module:


  2. Press the blue button on the boot media housing to release the boot media from its housing, and then gently pull it straight out of the boot media socket.
    Note
    Do not twist or pull the boot media straight up, because this could damage the socket or the boot media.
  3. Move the boot media to the new controller module, align the edges of the boot media with the socket housing, and then gently push it into the socket.
  4. Check the boot media to make sure that it is seated squarely and completely in the socket.
    If necessary, remove the boot media and reseat it into the socket.
  5. Push the boot media down to engage the locking button on the boot media housing.