To access components inside the controller, you must first remove the controller module from the system and then remove the cover on the controller module.
About this task
A video for this task is available at:
- If you are not already grounded, properly ground yourself.
- Loosen the hook and loop strap binding the cables to the cable management device, and then unplug the system cables and SFPs (if needed) from the controller module, keeping track of where the cables were connected.
Leave the cables in the cable management device so that when you reinstall the cable management device, the cables are organized.
- Remove and set aside the cable management devices from the left and right sides of the controller module.
- Loosen the thumbscrew on the cam handle on the controller module.
- Pull the cam handle downward and begin to slide the controller module out of the chassis.
Make sure that you support the bottom of the controller module as you slide it out of the chassis.
