Remove the SMM2 battery

Use this information to remove the SMM2 battery.

About this task

S002

CAUTION

The power-control button on the device and the power switch on the power supply do not turn off the electrical current supplied to the device. The device also might have more than one power cord. To remove all electrical current from the device, ensure that all power cords are disconnected from the power source.

S004

CAUTION

When replacing the lithium battery, use only Lenovo specified part number or an equivalent type battery recommended by the manufacturer. If your system has a module containing a lithium battery, replace it only with the same module type made by the same manufacturer. The battery contains lithium and can explode if not properly used, handled, or disposed of.

Do not:

• Throw or immerse into water
• Heat to more than 100°C (212°F)
• Repair or disassemble

Dispose of the battery as required by local ordinances or regulations.

S005

CAUTION

The battery is a lithium ion battery. To avoid possible explosion, do not burn the battery. Exchange it only with the approved part. Recycle or discard the battery as instructed by local regulations.

Attention

• Read Installation Guidelines and Safety inspection checklist to ensure that you work safely.

Procedure

1. Make preparations for this task.
   1. Remove the SMM2 and SMM2 support bracket. See Remove the SMM2.
   2. If you want to migrate current enclosure settings and the enclosure midplane VPD onto the new SMM2, make sure you have done the following:

      1. You had performed SMM2 settings backup, the enclosure VPD backup, and the midplane VPD backup procedures.

      2. Keep the old USB key which is removed from the SMM2 and install it onto the new SMM2.

2. Locate the battery.
   Figure 1. SMM2 battery location
   
   

   Table 1. SMM2 battery location

   1 SMM2 battery

3. Using your fingernail, press the battery retaining clip. The battery should pop free.
   Figure 2. SMM2 battery removal
   
   

   Note

   Do not lift the battery by using excessive force. Failing to remove the battery properly may damage the socket on the SMM2. Any damage to the socket may require replacing the SMM2.
4. Dispose of the battery as required by local ordinances or regulations. See Environmental Notices for more information.
5. Store original SMM2 VPD back to new SMM2 for warranty remaining, if it is replaced.