Skip to main content

Required documentation for Broadcom BES-53248 cluster switches

You need specific switch and controller documentation to set up your Cluster-Mode configuration.

Required documentation for Broadcom BES-53248 cluster switches

To set up the BES-53248 cluster switch, you need the following documents available from the Broadcom Support Site:
Document titleDescription
EFOS Administrator’s Guide v3.4.3Provides examples of how to use the Broadcom BES-53248 switch in a typical network.
EFOS CLI Command Reference v3.4.3Describes the command-line interface (CLI) commands you use to view and configure the Broadcom BES-53248 software.
EFOS Getting Started Guide v3.4.3Provides detailed information about for the Broadcom BES-53248 switch.
EFOS SNMP Reference Guide v3.4.3Provides examples of how to use the Broadcom BES-53248 switch in a typical network.
EFOS Scaling Parameters and Values v3.4.3Describes the default scaling parameters with which EFOS software is delivered and validated on the supported platforms.
EFOS Functional Specifications v3.4.3Describes the specifications for the EFOS software on the supported platforms.
EFOS Release Notes v3.4.3Provides release-specific information about Broadcom BES-53248 software.

Required documentation for supported ONTAP systems

To set up an ONTAP system, you need the following documents from the Lenovo Support Site at https://datacentersupport.lenovo.com/:

NameDescription
Lenovo PressDescribes the power and site requirements for all Lenovo hardware, including system cabinets.
Controller-specific Installation and Setup InstructionsDescribes how to install Lenovo hardware.
ONTAP 9.6Provides detailed information about all aspects of the ONTAP 9.6 release.