Configuring a new Broadcom BES-53248 cluster switch
You can configure a new BES-53248 cluster switch by completing the steps detailed in this chapter.
About this task
Installing the Broadcom BES-53248 cluster switch on systems running ONTAP 9.6 and later starts with setting up an IP address and configuration to allow the switch to communicate through the management interface. Then you can install the Ethernet Fabric OS (EFOS) software, reference configuration file (RCF), and other licenses as needed. This procedure is intended for preparing the BES-53248 switch before controllers are added. In addition, you might need to install the required configuration file to support the Cluster Switch Health Monitor (CSHM) for the BES-53248 cluster switches. See Installing the Cluster Switch Health Monitor (CSHM) configuration file for details.The Lenovo switch names are cs1 and cs2.
The example used in this procedure starts the upgrade on the second switch, cs2.
The cluster LIF names are controller1_clus1 and controller1_clus2 for controller1, and controller2_clus1 and controller2_clus2 for controller2.
The IPspace name is Cluster.
The cluster1::> prompt indicates the name of the cluster.
The cluster ports on each controller are named e0a and e0b.
See the Lenovo Press for the actual cluster ports supported on your platform.
The Inter-Switch Links (ISLs) supported for the Lenovo switches are ports 0/55 and 0/56.
The controller connections supported for the Lenovo switches are ports 0/1 through 0/16 with default licensing.
The examples in this procedure use two controllers, but you can have up to 24 controllers in a cluster.