Configuring the MetroCluster Tiebreaker or ONTAP Mediator software
You can download and install on a third site either the MetroCluster Tiebreaker software, or, starting with ONTAP 9.7, the ONTAP Mediator.
Before you begin
You must have a Linux host available that has network connectivity to both clusters in the MetroCluster configuration. The specific requirements are in the MetroCluster Tiebreaker or ONTAP Mediator documentation.
If you are connecting to an existing Tiebreaker or ONTAP Mediator instance, you need the username, password, and IP address of the Tiebreaker or Mediator service.
About this task
If you must install a new instance of the ONTAP Mediator, follow the directions to install and configure the software.
Configuring the ONTAP Mediator service for unplanned automatic switchover
If you must install a new instance of the Tiebreaker software, follow the directions to install and configure the software.
Tiebreaker software installation and configuration
You cannot use both the MetroCluster Tiebreaker software and the ONTAP Mediator with the same MetroCluster configuration.
Considerations for using ONTAP Mediator or MetroCluster Tiebreaker
– If you are using an existing instance of the ONTAP Mediator, add the ONTAP Mediator service to ONTAP using the following command:metrocluster configuration-settings mediator add -mediator-address ip-address-of-mediator-host
– If you are using the Tiebreaker software, refer to the Tiebreaker documentation.