添加 MetroCluster 配置

安装 Lenovo MetroCluster Tiebreaker 软件后，可以添加更多 MetroCluster 配置（一次添加一个）。

1. 使用 Tiebreaker 命令行界面（CLI）monitor add 命令添加 MetroCluster 配置。

   如果使用主机名，必须是标准域名（FQDN）。

   示例

   以下示例显示了 cluster_A 的配置：

   MetroCluster Tiebreaker :> monitor add wizard
   Enter monitor Name: cluster_A
   Enter Cluster IP Address: 10.222.196.130
   Enter Cluster Username: admin
   Enter Cluster Password:
   Enter Peer Cluster IP Address: 10.222.196.40
   Enter Peer Cluster Username: admin
   Enter Peer Cluster Password:
   Successfully added monitor to MetroCluster Tiebreaker software.
   
   
2. 使用 Tiebreaker CLI monitor show -status 命令确认已正确添加 MetroCluster 配置。

   示例

   MetroCluster Tiebreaker :> monitor show -status
   
3. 可选： 禁用 Tiebreaker 软件的观察者模式以在检测到站点故障后自动启动切换：monitor modify -monitor-name monitor_name -observer-mode false

   示例

   MetroCluster Tiebreaker :> monitor modify -monitor-name 8pack -observer-mode false
   Warning: If you are turning observer-mode to false, make sure to review the 'risks and limitations'
   as described in the MetroCluster Tiebreaker Installation and Configuration Guide.
   Are you sure you want to enable automatic switchover capability for monitor "8pack"? [Y/N]: y