Skip to main content

Installing a GPU tray into a compute node

Use this information to install a GPU tray in a NeXtScale nx360 M5 compute node.

Important
When you install the new GPU tray, you must update the GPU tray with the latest firmware. Make sure that you have the latest firmware before you proceed. See Updating the firmware for more information.
Note
The GPU tray supports only 1300-watt power supply unit with high-line Vin (AC 200 volt to 240 volt).
Before you install the compute node in a chassis, read Safety and Installation guidelines.

To install the GPU tray to compute node, complete the following steps:

  1. Carefully lay the GPU tray on a flat, static-protective surface, orienting the GPU tray with the release latch near your right hand side.
  2. Orient the GPU tray so that the posts on the inside of the GPU tray slide into the slots on the compute node.
    Note
    Before you install the GPU tray, make sure that the air baffles and all components are installed and seated correctly and that you have not left loose tools or parts inside the compute node.
    Figure 1. GPU tray installation
    Graphic illustrating the GPU tray installation
  3. Hold the front of the compute node and slide the GPU tray forward to the closed position, until it clicks into place.
  4. Reinstall the PCI riser-cage assembly in the GPU tray (see Replacing a PCI riser-cage assembly to the GPU tray).
  5. Connect the cables that were disconnected from the GPU tray.
  6. Replace the cover (see Installing the compute node cover).