Skip to main content

Power cords

Specific three-phase power cables are required for N1380 enclosure installed with SC750 V4 traysSC777 V4 trays.

To view the power cords that are available for the server:

  1. Go to:

    Data Center Solution Configurator

  2. Click Preconfigured Model or Configure to order.

  3. Enter the machine type and model for your server to display the configurator page.

  4. Click Power > Power Cables to see all line cords.

Note

  • For your safety, a power cord with a grounded attachment plug is provided to use with this product. To avoid electrical shock, always use the power cord and plug with a properly grounded outlet.

  • Power cords for this product that are used in the United States and Canada are listed by Underwriter’s Laboratories (UL) and certified by UL standard and Canadian standard (CSA standards) with certification mark of UL and C-UL.

  • For Y-splitter power cord units intended to be operated at three-phase 380-415 volts with IEC 60309 (U.S. use): Use a UL-listed, UL-certified, and CSA-certified cord set consisting of a maximum 60 amperes. This Y-splitter power cord is for Lenovo special use, and the middle connector of the cable shall not be hot-plugged.

  • For units intended to be operated at three phase 380-415 volts with IEC 60309 (U.S. use): Use a UL-listed, UL-certified, and CSA-certified cord set consisting of a maximum 30 amperes.

  • Power cords for a specific country or region are usually available only in that country or region.