Skip to main content

Install the top cover

Follow instructions in this section to install the top cover.

About this task

To avoid potential danger, make sure to read and follow the safety information.

Attention

Procedure

  1. Align the top cover guide pins with the guide holes on the node; then, place the top cover onto the top of the node and slide it towards the front of the node until it engages with the node.
  2. Check and make sure that the button on the side of the top cover is in locked position.
    Figure 1. Installation of the top cover
    Installation of the top cover

After you finish

  1. Reinstall the node into the chassis (see Install a node to the chassis).
  2. Make sure that the required power supply units are installed and power cords are connected; then, power on the node (see Install a hot-swap power supply and Power on the node).
  3. Proceed to complete the parts replacement (see Complete the parts replacement).