Skip to main content

Remove a hot-swap drive

Follow instructions in this section to remove a hot-swap drive.

About this task

Attention
  • Make sure to save the data on the drive, especially if it is part of a RAID array, before removing it from the node.
  • To avoid damage to the drive connectors, make sure that the node top cover is installed and fully closed whenever installing or removing a drive.
  • To make sure that there is adequate system cooling, do not operate the node for more than two minutes without either a drive or a filler installed in each drive bay.
  • If one or more NVMe solid-state drives are to be removed, it is recommended to disable them beforehand via the operating system.
  • Before removing or making changes to the drives, drive controllers (including controllers that are integrated on the system board), drive backplanes, or drive cables, make sure to back up all important data that is stored on the drives.
  • Before removing any component of a RAID array (drive, RAID card, etc.), back up all RAID configuration information.
  • Make sure to have the drive bay fillers readily available if some drive bays will be left empty after the removal.

Remove a 2.5-inch hot-swap drive​

Procedure

  1. Make preparations for this task.
    1. Identify the hot-swap drive to be removed.
    2. Make sure to save the data on the drive before removing it from the node.
  2. Remove the hot-swap drive.
    1. Slide the latch to unlock the drive handle.
    2. Open and hold the handle.
    3. Pull the drive out of the drive bay.
    Note
    • Depending on the specific configuration, the hot-swap drive to be removed may be a 7 mm or 15 mm 2.5-inch solid-state drive. The removal procedures are the same.
    • In the right bay (seen from the front), the node must be installed upside down. From this node, the drive to be removed is also upside down, but the removal procedures are the same.
    Figure 1. Removal of a solid-state drive
    Solid-state drive removal

After you finish

  1. Install a replacement unit or filler (See Install a hot-swap drive.)
    Important
    During normal operation, the drive bay must contain either a drive or a drive filler for proper cooling.
    Figure 2. Replacement of a drive filler
    Replacement of a drive filler
  2. If you are instructed to return the component or optional device, follow all packaging instructions, and use any packaging materials for shipping that are supplied to you.

Demo video

Watch the procedure on YouTube