Skip to main content

Remove the front I/O board

Follow instructions in this section to remove the front I/O board.

About this task

To avoid potential danger, make sure to read and follow the safety information.

Attention

Read Installation Guidelines and Safety inspection checklist to make sure that you work safely.

Procedure

  1. Make preparations for this task.
    1. Power off the node (see Power off the node); then, disconnect all external cables from the node.
    2. Remove the node from the chassis (see Remove a node from the chassis); then, carefully lay the node on a flat, static-protective surface, orienting the node with the front toward you.
    3. Remove the top cover (see Remove the top cover).
    4. Disconnect all the cables from the front I/O board.
  2. Remove the front I/O board from the drive cage.
    1. Rotate both plungers counterclockwise to the unlocked position to disengage the front I/O board from the drive cage.
    2. Pull up the front I/O board and push it lightly toward the rear of the node; then, continue to pull the board out of the drive cage.
      Figure 1. Removal of the front I/O board
      Removal of the front I/O board

After you finish

  1. Install a replacement unit (see Install the front I/O board).
  2. If you are instructed to return the component or optional device, follow all packaging instructions, and use any packaging materials for shipping that are supplied to you.

Demo video

Watch the procedure on YouTube