Skip to main content

Remove the drip sensor assembly

Use this information to remove the drip sensor assembly.

About this task

S002
disconnect all power
CAUTION
The power-control button on the device and the power switch on the power supply do not turn off the electrical current supplied to the device. The device also might have more than one power cord. To remove all electrical current from the device, ensure that all power cords are disconnected from the power source.
Attention
Watch the procedure
  • A video of this procedure is available at YouTube.

Procedure

  1. Remove the EMC shields. See Remove an EMC shield.
  2. Remove the drip sensor assembly.
    1. Push the latch up upwards.
    2. Slide the drip sensor assembly backwards, then; lift the drip sensor assembly up to clear sensor post and pull it out of the enclosure.
    Figure 1. Drip sensor assembly removal
    Drip sensor assembly removal
    Figure 2. Drip sensor assembly
    Drip sensor assembly
    Table 1. Drip sensor assembly
    1 Connector2 Latch

After you finish

If you are instructed to return the component or optional device, follow all packaging instructions, and use any packaging materials for shipping that are supplied to you.