Remove a PCIe riser assembly (ConnectX-7 NDR 400)
Use this information to remove a PCIe riser assembly with ConnectX-7 NDR 400 adapter.
About this task
Required tools
Attention
Read Installation Guidelines and Safety inspection checklist to ensure that you work safely.
Turn off the corresponding DWC tray that you are going to perform the task on.
Disconnect all external cables from the enclosure.
Use extra force to disconnect QSFP cables if they are connected to the solution.
Watch the procedure
- A video of this procedure is available at YouTube.
Procedure
- Make preparations for this task.
- Remove the tray from the enclosure. See Remove a DWC tray from the enclosure.
- Remove the tray cover. See Remove the tray cover.
- For shared I/O or socket direct configurations, disconnect the cable from the system board. See SD650-I V3 internal cable routing.
- Remove the PCIe riser assembly.
- If necessary, remove the interface plate.
After you finish
If you are instructed to return the component or optional device, follow all packaging instructions, and use any packaging materials for shipping that are supplied to you.
If you need to disassemble the PCIe riser assembly, follow the instructions below:
Attention
You can only disassemble a PCIe riser assembly for recycle. Do not disassemble it for any other purposes.
Remove the two screws, then, separate the expansion board from the cage.
Figure 8. Expansion board removalRecycle the unit in compliance with local regulations.
Give documentation feedback