Skip to main content

System Management Module 2 (SMM 2) LEDS

The following illustration shows the LEDs on the SMM2 module.

Figure 1. SMM2 LEDs
SMM2 LEDs
Table 1. SMM2 connectors and LEDs
1 Identification LED (blue)5 Ethernet port 2 link (RJ-45) LED (green)
2 Power LED (green)6 Ethernet port 2 activity (RJ-45) LED (green)
3 Status LED (green)7 Ethernet port 1 link (RJ-45) LED (green)
4 Check log LED (yellow)8 Ethernet port 1 activity (RJ-45) LED (green)

1 Identification LED: When this LED is lit (blue), it indicates the enclosure location in a rack.

2 Power-on LED: When this LED is lit (green), it indicates that the SMM2 has power.

3 Status LED: This LED (green) indicates the operating status of the SMM2.

  • Continuously on: The SMM2 has encountered one or more problems.

  • Off: When the enclosure power is on, it indicates the SMM2 has encountered one or more problems.

  • Flashing: The SMM2 is working.

    • During the pre-boot process, the LED flashes rapidly.

      • Ten times per second: The SMM2 hardware is working and the firmware is ready to initialize.

      • Two times per second: The firmware is initializing.

    • When the pre-boot process is completed and the SMM2 is working correctly, the LED flashes at a slower speed (about once every two seconds).

4 Check log LED: When this LED is lit (yellow), it indicates that a system error has occurred. Check the SMM2 event log for additional information.

5 Ethernet port 2 link (RJ-45) LED: When this LED is lit (green), it indicates that there is an active connection through the remote management and console (Ethernet) port 2 to the management network.

6 Ethernet port 2 activity (RJ-45) LED: When this LED is flashing (green), it indicates that there is an activity through the remote management and console (Ethernet) port 2 over the management network.

7 Ethernet port 1 link (RJ-45) LED: When this LED is lit (green), it indicates that there is an active connection through the remote management and console (Ethernet) port 1 to the management network.

8 Ethernet port 1 activity (RJ-45) LED: When this LED is flashing (green), it indicates that there is an activity through the remote management and console (Ethernet) port 1 over the management network.