The following information is a summary of the features and specifications of the server. Depending on the model, some features might not be available, or some specifications might not apply.
Table 1. Server Specifications
Specification
Description
Size
1U server
Height: 43.0 mm (1.7 inches)
Width:
With rack latches: 481.7 mm (18.9 inches)
Without rack latches: 434.4 mm (17.1 inches)
Depth: 497.8 mm (19.6 inches)
Note: The depth is measured from the front mounting flange of the rack to the rear of the server.
Weight
Approximately 6.1 kg (13.4 lb) to 12.3 kg (27.1 lb) depending on model
Processor (depending on the model)
Support up to one Intel® multi-core processor from Core™, Pentium® , Celeron® and Xeon® E processor family
QLogic QL41262 PCIe 25Gb 2-Port SFP28 Ethernet Adapter does not support shared storage V3700v2 and V5030 configurations.
RAID
RAID adapter is supported when PCIe riser assembly is installed
Software RAID level: 0, 1, 5, and 10
Hardware RAID level: 0, 1, 5, 6, and 10
Note
When all four storage drives have been installed, and the system has been set to software RAID mode in the UEFI settings, regardless if the disks are configured as an array or as separate disks, drives 2 and 3 cannot be used to install the Windows operating system.
If the M.2 drive has been installed, and the system has been set to software RAID mode in the UEFI settings, regardless if the disks are configured as an array or as separate disks, the M.2 drive cannot be used to install the Windows operating system.
Fans
Three internal system non-hot-swap fans (40mm x 28mm)
One M.2 or one HDD with backplate (if OS is needed for debugging)
Acoustical noise emissions
Approximate sound level:
Sound power levels, idle
4.7 bels, minimum
4.7 bels, typical
4.9 bels, maximum
Sound power levels, operating
5.2 bels, minimum
5.2 bels, typical
5.5 bels, maximum
Note
These sound power levels are measured in controlled acoustical environments according to procedures specified by ISO 7779 and are reported in accordance with ISO 9296.
The declared acoustic noise levels are based on specified configurations, which may change slightly depending on configurations/conditions.
Heat output
Approximate heat output:
Minimum configuration: 180 BTU, 53 W (in BTU per hour and watts)
Maximum configuration: 771 BTU, 226 W (in BTU per hour and watts)
Environment
The ThinkSystem SR150 server complies with ASHRAE Class A2 specifications. System performance may be impacted when operating temperature is outside ASHRAE A2 specification or fan failed condition. The ThinkSystem SR150 server is supported in the following environment:
Air temperature:
Operating:
ASHRAE Class A2: 10°C to 35°C (50°F to 95°F); decrease the maximum ambient temperature by 1°C for every 300 m (984 ft) increase in altitude above 900 m (2,953 ft)
Server off: 5°C to 45°C (41°F to 113°F)
Shipment/Storage: -40°C to 60°C (-40°F to 140°F)
Maximum altitude: 3,050 m (10,000 ft)
Relative Humidity (non-condensing):
Operating:
ASHRAE Class A2: 8% to 80%, maximum dew point: 21°C (70°F)
Shipment/Storage: 8% to 90%
Particulate contamination
Airborne particulates and reactive gases acting alone or in combination with other environmental factors such as humidity or temperature might pose a risk to the server. For information about the limits for particulates and gases, see Particulate contamination.
Particulate contamination Attention: Airborne particulates (including metal flakes or particles) and reactive gases acting alone or in combination with other environmental factors such as humidity or temperature might pose a risk to the device that is described in this document.